drum to disc brake conversion cost

How to Assemble a Drum Brake Assembling a drum brake might seem daunting, but with the right tools, knowledge, and a step-by-step approach, it can be a manageable task. Drum brakes are commonly found in older vehicles as well as in some modern models. This article will guide you through the process of assembling a drum brake, helping you understand the components involved and the procedures to follow. Tools and Materials Needed Before starting, ensure you have all necessary tools and materials at hand - Drum brake kit (including shoes, springs, adjuster, and hardware) - Brake clean - Wrenches and sockets - Screwdriver - Pliers - Torque wrench - Safety glasses and gloves Step 1 Preparation Begin by placing the drum brake assembly on a clean, flat surface. Make sure to wear your safety gear to protect against any sharp edges or debris. Clean the components using brake cleaner to remove any dust, grease, or grime that may interfere with the assembly. Inspect all parts to ensure they are in good condition; replace any worn out or damaged components. Step 2 Assemble the Brake Shoes The drum brake typically consists of two brake shoes attached to a backing plate. These shoes are lined with friction material that presses against the drum to create braking force. Position the primary shoe (usually has a larger radius at the top) on the backing plate, aligning it with the pivot point. Secure it in place using the appropriate hardware. Next, take the secondary shoe and position it in the same way. When assembled correctly, the shoes should be able to pivot freely . Make sure that the leading and trailing edges of the shoes are in the correct orientation, as improper alignment can lead to uneven braking. Step 3 Install the Adjuster how to assemble a drum brake The adjuster is a critical component that keeps the brake shoes at the correct distance from the drum. Install the adjuster by placing it between the two shoes. Ensure that it is connected to the shoes with the adjuster arm properly oriented for adjustment. Some kits may require you to use a spring or clip to secure it into place. Step 4 Attach the Springs Now it’s time to install the springs that hold the shoes in place and help them retract after braking. Start by installing the hold-down springs at each brake shoe pivot point. Use a spring tool or pliers to compress the springs and slide them onto their posts. Follow this by installing the return springs; one typically connects between the shoes. This spring allows the shoes to pull back after the brakes are released. Step 5 Install the Brake Drum With the shoes fully assembled, the next step is to mount the brake drum. Before installing, check that the drum is clean and free of any debris. Place the drum over the assembled brake shoes, ensuring that the shoes fit inside the drum without obstruction. Rotate the drum by hand to check for any binding, making adjustments if necessary by re-aligning the shoes or adjusting the adjuster. Step 6 Final Checks Once the drum is in place, ensure all components are secure and correctly aligned. Recheck the adjustment of the shoes to make sure they have sufficient clearance with the drum. The braking system should not drag; a slight gap should allow for smooth operation. With everything in place, you can now reinstall the wheel and lower the vehicle. Remember to pump the brakes a few times before driving to ensure proper function. Conclusion Assembling a drum brake requires attention to detail and proper technique. By following these steps, you can successfully assemble a drum brake Assembly and ensure your vehicle’s braking system functions correctly. Always refer to your vehicle's service manual for specific instructions and guidelines. With patience and practice, this task can become an easy and rewarding part of vehicle maintenance.

本文地址：https://www.ningchaibrakedrum.com/DrumBrakesKB/4/4224.html