drum to disk brake conversion

How to Change Drum Brake Pads Changing drum brake pads is an essential maintenance task that can significantly enhance your vehicle's braking performance and safety. While it may seem daunting, with the right tools and a bit of confidence, you can tackle this project yourself. Below, we will outline the process step-by-step, ensuring you have all the necessary information to successfully change your drum brake pads. Tools and Materials Needed Before you get started, make sure you have the following tools and materials on hand 1. Jack and Jack Stands To lift the vehicle safely. 2. Lug Wrench To remove the wheel bolts. 3. Brake Drum Removal Tool If the drums are stuck. 4. Brake Cleaner To clean the components. 5. New Brake Pads Make sure they fit your vehicle. 6. C-clamp or Brake Piston Tool To compress the brake piston. 7. Gloves and Safety Goggles To protect yourself. Step 1 Preparation First, ensure your vehicle is parked on a flat surface. For safety, engage the parking brake. Use a lug wrench to loosen, but not completely remove, the lug nuts on the rear wheels. Then, use the jack to lift the vehicle and secure it with jack stands. Once stable, you can remove the lug nuts and take off the rear wheels. Step 2 Inspect the Brake Assembly With the wheel off, inspect the drum brake assembly. Look for signs of wear on the brake pads and drums. If the drum surface is scratched or grooved, it may need machining or replacement. It's also wise to check the springs and hardware for any damage. Step 3 Remove the Brake Drum If the brake drum is stuck, gently tap around its edges with a hammer to loosen it. If it still does not budge, use a brake drum removal tool for assistance. Once free, pull the drum off and examine the brake shoes and other components to ensure they are in good condition. Step 4 Remove Old Brake Pads how to change drum brake pads To replace the brake pads, you may need to remove the hold-down springs or pins that hold the pads in place. Carefully take out the old pads, paying attention to how they are installed. It may be helpful to take pictures for reference when installing the new pads. Step 5 Install New Brake Pads Take your new brake pads and install them in the same orientation as the old ones. Make sure they are securely seated against the backing plate. Reattach any springs or pins that were removed. Step 6 Compress the Brake Piston Before reassembling the drum, use a C-clamp or a brake piston tool to compress the brake piston back into its housing. This allows enough space for the new pads to fit. Be cautious not to damage the piston during this process. Step 7 Reassemble the Brake Drum Once the pads are in place and the piston is compressed, carefully reattach the brake drum. Make sure it spins freely and doesn’t rub against the pads. If everything looks good, reinstall the wheel and hand-tighten the lug nuts. Step 8 Lower the Vehicle and Test Lower the vehicle from the jack stands and snug the lug nuts to the manufacturer's specifications using a torque wrench. Before taking the car out, pump the brake pedal a few times to ensure the pads seat properly against the drums. Conclusion Changing drum brake pads can be a rewarding DIY project that saves you money and enhances your vehicle's performance. Always remember to follow safety procedures and refer to your vehicle’s manual for specific instructions and specifications. Regular brake maintenance is crucial for safe driving, so make it a part of your vehicle care routine. If you feel uncertain at any step, don’t hesitate to seek professional assistance.

本文地址：https://www.ningchaibrakedrum.com/DrumBrake5/4/3109.html