how do you replace rear drum brakes

How to Remove Wheel Studs from Drum Brakes Removing wheel studs from drum brakes may seem like a daunting task, but with the right tools and steps, it can be accomplished efficiently. Whether you're replacing worn-out studs or performing a brake overhaul, here’s a step-by-step guide. Tools You'll Need Before you start, gather the necessary tools - Socket set or wrench - Hammer - Pliers - Wheel stud installer or bolt extractor (optional) - Lubricating oil - Torque wrench - Safety goggles - Jack and jack stands Safety First Before you start any vehicle work, ensure safety is your priority. Engage the parking brake, wear safety goggles, and work on a flat, stable surface. If you’re lifting the vehicle, use jack stands to secure it after raising it with a jack. 1. Remove the Wheel The first step in removing the wheel studs is to take off the wheel itself. Begin by loosening the lug nuts with a socket wrench while the wheel is still on the ground. Once they are loose, lift the vehicle with a jack and then remove the wheel completely. 2. Access the Drum Brake Assembly After removing the wheel, you may need to remove the brake drum. To do this, inspect the drum for any retaining screws or clips that may need to be removed. If the drum is seized, gently tap it with a hammer to loosen it. Make sure to avoid hitting it too hard to prevent damage. 3. Remove Brake Components Once the drum is off, you may need to remove additional components like the brake shoes and hardware. Take pictures as you go or make notes to help with reassembly later. The brake shoes are typically held in place by springs and clips. Use pliers to carefully remove these components. 4. Extracting the Wheel Studs how to remove wheel studs drum brakes Now that you have access to the wheel studs, you’ll need to remove them. If necessary, apply some lubricating oil to the area where the studs meet the hub to ease the removal process. To remove each stud, place a hammer against the back of the stud and strike it gently. If the stud is stubborn, a stud extractor can be used. Fit the extractor over the stud and turn it counterclockwise; the extractor will grip the stud and help pull it out. 5. Installing New Wheel Studs With the old studs removed, it’s time to install the new ones. Insert the new stud from the back of the hub and push it through until it protrudes from the front. To secure the stud, you can use a lug nut. Place a lug nut over the stud and tighten it with your socket wrench while supporting the back of the hub. This helps draw the stud in evenly. 6. Reassemble the Brake Assembly After installing the new wheel studs, reassemble the brake components in the reverse order of removal. Make sure that all springs and clips are secured, and the brake shoes are properly positioned. 7. Reattach the Brake Drum and Wheel Once everything is back in place, slide the brake drum over the new studs. If the drum was difficult to get off, it may also be snug going back on, so a gentle tap might be required. Finally, reattach the wheel, hand-tighten the lug nuts, and lower the vehicle back to the ground. 8. Final Checks After lowering the vehicle, use your torque wrench to tighten the lug nuts to the manufacturer’s specified torque. This ensures that everything is secure and safe for driving. Conclusion Removing wheel studs from drum brakes requires attention to detail and safety precautions. By following these steps, you can accomplish this task effectively and keep your brake system functioning optimally. If you're unsure at any point, don’t hesitate to consult with a professional mechanic. Safe driving!

本文地址：https://www.ningchaibrakedrum.com/DrumBrake6SWNMJEB/2/245.html