do rear drum brakes have rotors

Drum Brake Overhaul A Comprehensive Guide Drum brakes are a common type of braking system used in many vehicles, particularly in older models or certain heavier vehicles like trucks and buses. Over time, these brakes can wear down and become less effective, necessitating an overhaul to ensure safe and reliable operation. This article will guide you through the process of overhauling drum brakes, covering the necessary steps, tools, and tips for success. Understanding Drum Brakes Before diving into the overhaul process, it's essential to grasp how drum brakes function. In a drum brake system, friction is generated between brake shoes and the inner surface of a rotating drum. When the brake pedal is pressed, hydraulic pressure forces the brake shoes against the drum, creating the necessary friction to slow down or stop the vehicle. Over time, components can wear out due to heat, moisture, and general use, leading to decreased braking performance. Tools and Materials Needed To begin the overhaul, gather the following tools and materials 1. Tools - Jack and jack stands - Lug wrench - Brake shoe tool - Torque wrench - Screwdrivers (flat and Phillips) - Pliers - Wire brush - Brake cleaner - Vacuum cleaner - Safety goggles and gloves 2. Materials - New brake shoes - Brake drums (if needed) - Brake hardware kit (springs, clips, etc.) - Lubricant for brake parts - Brake fluid (if necessary) Step-by-Step Overhaul Process 1. Preparation - Park the vehicle on a level surface and engage the parking brake. - Loosen the lug nuts slightly while the wheel is still on the ground. drum brake overhaul 2. Lifting the Vehicle - Use a jack to lift the vehicle and secure it with jack stands for safety. - Remove the wheel using the lug wrench. 3. Accessing the Drum - Remove any retaining clips or screws that hold the drum in place. - Gently slide the drum off the wheel hub. If it’s stuck, it may require some gentle tapping. 4. Inspecting Components - Check the brake shoes for wear. If the friction material is worn down to 1/8 inch or less, they should be replaced. - Inspect the brake drums. Measure the inner diameter; if it's out of specification, it may need to be resurfaced or replaced. 5. Cleaning - Clean the brake components with brake cleaner to remove dust and debris. - Use a wire brush to clean the backing plate and other metal surfaces. 6. Replacing Brake Shoes - Remove the old brake shoes by detaching the springs and retaining clips using the brake shoe tool. - Install the new brake shoes, making sure they are oriented correctly. Secure them with the new springs and hardware from the kit. 7. Reassembling the Drum - Before reassembling, apply a thin layer of lubricant to the areas specified in the instructions to prevent squeaking and ensure smooth operation. - Carefully slide the drum back onto the wheel hub, making sure it sits properly. 8. Reinstalling the Wheel - Reattach the wheel and hand-tighten the lug nuts. Lower the vehicle back to the ground and use the torque wrench to tighten the lug nuts in a crisscross pattern to the manufacturer’s specification. 9. Final Checks - Before driving, check the brake fluid level and top up if necessary. - Test the brakes gently in a safe area to ensure proper function. Conclusion Overhauling drum brakes is an essential maintenance task that can significantly improve your vehicle's safety and performance. While this task may seem daunting, with the right tools and patience, it can be accomplished by most DIY enthusiasts. Regular brake maintenance not only extends the life of your braking components but also enhances overall vehicle reliability. Always remember to consult your vehicle's manual for specific instructions and specifications related to your model. Safe driving begins with well-maintained brakes!

本文地址：https://www.ningchaibrakedrum.com/DrumBrakePDyYWQ/4/3528.html